Four lead wires, easy to use, plus driving voltage 5-10V, force changes in the output voltage signal directly.Installation: Sensor end through the screw hole fixed and the other end left floating state, according to the label indicates the direction of the gravitational force exerted particular atte..
Do you have a good understanding of various sensors or need a variety of them for a project? This kit includes a sensor for just about every job. With everything included in this kit, you’ll be able to sense gesture, humidity, temperature, motion, touch, sound, and more! These are some of our ..
38KHz Digital IR Receiver Sensor Module For Arduino IR is widely used in remote control. With this IR receiver, the Arduino project is able to receive command from any IR remoter controller if you have the right decoder. Well, it will be also easy to make your own IR controller using ..
Use this module to detect flame in large range( >120 degree). If you want you robot detect if there is any fire around, this module is just for you. It detects the fire with 5 flame sensors which are arranged with 30 degrees. This module outputs analog signal, which would be more precisely, and a..
1. It adopts Doppler radar technology, with auto-sensing capabilities to control other product.2. High sensitivity, sensor distance, reliability, wide angle sensor, wide supply voltage range and other characteristics.3. Widely used in lighting situations,anti-theft alarm situations.Features :1. Micr..
A photoresistor or LDR 5mm – Light Dependent Resistor is a resistor whose resistance decreases with increasing incident light intensity; in other words, it exhibits photoconductivity.A photo-resistor is made of a high resistance semiconductor. If light falling on the device is of..
1. Current sensor chip: ACS712ELC-30A;2. Pin 5V power supply, on-board power indicator;3. Tthe module can be measured plus or minus 30 amps, corresponding to the analog output 66mV / A;4. There is no the detection current through, the output voltage is VCC / 2;5. PCB board size: 31 (mm) x13 (mm..
Specification:Low-noise analog signal path.5 µs output rise time in response to step input current.50 kHz bandwidth.Total output error 1.5% at TA= 25°C, and 4% at –40°C to 85°C.Small footprint, low-profile SOIC8 package.1.2 mΩ internal conductor resistance.2.1 kV RMS minimum isolation voltage from p..
DESCRIPTIONADXL345 Digital 3-Axis Acceleration Gravity Tilt Sensor Module. The ADXL345 is a small, thin, low -power three-axis accelerometer, can be high Up to ± 16 g acceleration with high resolution (13) measurements. Digital Outputs According to 16-bit two’s complement format, Or I..
The AM2302 is a wired in a large plastic body. It is a basic, low-cost digital temperature and humidity sensor. It uses a capacitive humidity sensor and a thermistor to measure the surrounding air, and spits out a digital signal on the data pin (no analog input pins needed). Its fairly simple ..
Arduino MEGA Sensor Shield in Pakistan motherboard will not only be extended to the steering gear line order form ad hoc Bluetooth modulecommunication interface, SD card module communication interface, APC220 radio frequency module communication interface, and RB URF v1.1 ultrasonic s..