Menu
Your Cart
Raspberry PI 3 Model B+ Available Shop now

Arduino

Arduino
Model: Arduino Modules
1. Input voltage: 2.5V-6V2. Output voltage: 4V-12V (adjustable)3. Output Current: 1000mA (Max)4. Conversion efficiency: 92% (the highest)5. Switching frequency: 1MHz6. Output ripple: 20mV (max)7. Load Regulation: ± 0.5%8. Voltage Regulation: ± 2.5%9. Size : 20mmX20mmX5mm/0.78”X0.78”X0.19”10. Module ..
Rs 150.00
Model: Arduino Modules
Digital 8-Bit TM1638 LED Module For Arduino PIC AVR contain eight 7-segment red LED digits, eight red/green LEDs and also eight buttons for user input. For Arduino use, pins 1~4 are the minimum necessary to use one module. Each additional module will require another digital pin connected to STB..
Rs 350.00 Rs 320.00
Model: Arduino Modules
DS1307 RTC Real Time Clock Module with real time clock DS1307 and battery back-up. It allows you to read time in the form of hours, minutes and seconds and dates: month, day, year. It has 32 kb EEPROM memory. The communication interface is the I2C bus (lines SDA and SCL) , the data re..
Rs 120.00
Model: Arduino Modules
HC 05 HC-05 HC05 Bluetooth Module in Pakistan in Pakistan module is an easy to use Bluetooth SPP (Serial Port Protocol) module, designed for transparent wireless serial connection setup.Serial port Bluetooth module is fully qualified Bluetooth V2.0+EDR (Enhanced Data Rate) 3Mbps Modulation with..
Rs 400.00
HC-SR04 UltraSonic Sensor
-13 %
Model: Arduino Sensors
Ultrasonic sensor operating in the range of 2-200 cm. Powered by 5 V. The output is a signal whose duration is proportional to the measured distance.SpecificationPower supply: 5 VAverage power consumption: 15 mAMeasuring range: from 2 cm to 200 cmOutput: frequency signalOperating frequency: 40 ..
Rs 150.00 Rs 130.00
Model: Arduino Modules
This LCD2004 is a great I2C interface for 2×16 and 4×20 LCD displays. With the limited pin resources, your project may be out of resources using normal LCD shield. With this I2C interface LCD module, you only need 2 lines (I2C) to display the information. If you already has I2C device..
Rs 120.00
Model: Motor Drivers
L9110S Dual DC Motor Driver H-bridge Stepper Motor controller module uses L9110 IC, which makes it possible to control one Stepper Motor or two DC Motors . The supply voltage is from 3 V to 12 V. Continuous current up to 800 mA. The module is equipped with a 6-pin goldpin st..
Rs 150.00
Showing 13 to 24 of 50 (5 Pages)