The gravity arduino turbidity sensor detects water quality by measuring the levels of turbidity. It uses light to detect suspended particles in water by measuring the light transmittance and scattering rate, which changes with the amount of total suspended solids (TSS) in water. As the TTS..
Ultrasonic sensor operating in the range of 2-200 cm. Powered by 5 V. The output is a signal whose duration is proportional to the measured distance.SpecificationPower supply: 5 VAverage power consumption: 15 mAMeasuring range: from 2 cm to 200 cmOutput: frequency signalOperating frequency: 40 ..
The driver uses high-power driver chip BTS7960 composed of H bridge driver module, with over-temperature over-current protection. BTS7960 H bridge driver circuit, with strong drive and brake effects, the use of 74HC244 chip effectively isolated SCM and motor drive! High current 43A!
Up to 43A sup..
This LCD2004 is a great I2C interface for 2×16 and 4×20 LCD displays. With the limited pin resources, your project may be out of resources using normal LCD shield. With this I2C interface LCD module, you only need 2 lines (I2C) to display the information. If you already has I2C device..
This L293D Motor Driver/Servo Shield for Arduino is probably one of the most versatile on the market and features 2 servo and 4 motor connectors for DC or stepper motors. That makes it a great shield for any robotic project. This Arduino compatible motor Driver shield is a full-featured product that..
This L298N Based Motor Driver Module is a high power motor driver perfect for driving DC Motors and Stepper Motors. It uses the popular L298 motor driver IC and has the onboard 5V regulator which it can supply to an external circuit. It can control up to 4 DC motors, or 2 DC motors with directional ..
L9110S Dual DC Motor Driver H-bridge Stepper Motor controller module uses L9110 IC, which makes it possible to control one Stepper Motor or two DC Motors . The supply voltage is from 3 V to 12 V. Continuous current up to 800 mA. The module is equipped with a 6-pin goldpin st..
Module parameters:1.single module can drive an 8 * 8 common cathode lattice2.module operating voltage: 5V3.with four screws hole, aperture 3mm, Our M3 Tongzhu fixed4.modules with input and output interface, supports multiple modules cascadeWiring instructions:Module on the left as an input port, out..