Your Cart
اپناآڈر پلیس کرنے کے بعد ہمیں اس نمبرپر 03429472107 کال یا وٹس ایپ کرکےآڈر نمبر بتا آڈر کنفرم کروائیں۔ تاکہ آپ کے آڈر کو جلدازجلد شپ کیا جاسکے۔ شکریہ

16 Channel PCA9685 12-bit PWM Servo Motor Driver

16 Channel PCA9685 12-bit PWM Servo Motor Driver

– A product for Arduino that works with official Arduino boards.

– This is a i2c-controlled PWM driver board with a built-in clock, which is quite different from TLC5940 series. You don’t need to continuously send signals and occupy your MCU.

– 5V compatibility, which means that you can use 3.3V MCU to control and drive the output up to 6V (when you want to control the white or blue indicator light, 3.4V+ is also OK).

– 6 address select pins allow you to connect 62 driver boards to one i2C bus, total 992 channels of PWM output.

– About 1.6KHz frequency modulation PWM output.

– Get 12-bit resolution output ready for stepping motor, which means that the 60Hz update rate can reach to 4us resolution.

– Configurable totem-pole output or open-collector output.

– Output enable pin can quick disable all outputs.

– PCA9685 chip is at the center of the board.

– With power input terminal.

– With green power indicator light.

– Convenient to insert total 16 servos at the same time (the plug of servo is a little large than 0.1″, so you can put 4 pairs of 0.1″ connectors).

– With reverse polarity protection for input.

– Cascade design.

– Put a bulky capacitor on the V+ line (sometimes you need it).

– Put 220 ohm resistance components onto all PWM output lines, so as to protect them, and you can easily drive the LED.

Write a review

Note: HTML is not translated!
Bad Good
16 Channel PCA9685 12-bit PWM Servo Motor Driver
  • Stock: In Stock
  • Model: Motor Driver
  • Weight: 0.10kg
  • SKU: Z03501
Product Views: 724
Rs 450.00